What is the point of a "plain" begin-end block?

verilog system-verilog
Randomblue picture Randomblue · Apr 2, 2012 · Viewed 10.7k times · Source

I'm reading some third party Verilog, and found this:

function [31:0] factorial;
    input [3:0] operand;
    reg [3:0] index;

    begin
        factorial = operand ? 1 : 0;
        for(index = 2; index <= operand; index = index + 1)
        factorial = index * factorial;
    end
endfunction

It seems that the begin and end keywords are redundant here. Are they? What is their use?

Answer

Tim picture Tim · Apr 2, 2012

I don't know about the general case, but in this specific case:

If a function contains more than one statement, the statements must be
enclosed in a begin-end or fork-join block.

Source: Verilog Golden Reference Guide

Related questions

Verilog: How to instantiate a module

If I have a Verilog module 'top' and a verilog module 'subcomponent' how do I instantiate subcomponent in top? top: module top( input clk, input rst_n, input enable, input [9:0] data_rx_1, input [9:0] data_rx_2, output [9:0] data_tx_2 ); subcomponent: module …

Read More
$size, $bits, verilog

What is the difference between $size and $bits operator in verilog.? if I've variables, [9:0]a,[6:0]b,[31:0]c. c <= [($size(a)+$size(b)-1]-:$bits(b)]; What will be the output at 'c' from the above expression?

Read More
What is the difference between single (&) and double (&&) ampersand binary operators?

In IEEE 1800-2005 or later, what is the difference between & and && binary operators? Are they equivalent? I noticed that these coverpoint definitions behave identically where a and b are of type bit: cp: coverpoint a & b; …

Read More