How do I clear a Direct2D render target to fully transparent

Saul picture Saul · Apr 8, 2010 · Viewed 9.7k times · Source

I'm trying to draw semi-transparent rectangles on an invisible HWND. However, clearing the window with ID2D1HwndRenderTarget::Clear just makes the entire window black, so when I draw rectangles on top, they look semi-black.

If I don't Clear() and don't draw, then the window is invisible, as it should be. Clear() is the culprit here; however if I don't use it then painting messes up pretty badly.

Here's the code I'm using in my WindowProc:

case WM_PAINT:
    // Begin drawing
    pRenderTarget->BeginDraw();
    pRenderTarget->SetTransform(D2D1::Matrix3x2F::Identity());

    // Clear the window
    pRenderTarget->Clear();

    // Paint the panel and its children
    D2DSurface()->StartPainting();
    {
        D2DSurface()->PaintTraverse(panel);
    }
    D2DSurface()->FinishPainting();

    // Finish drawing
    HRESULT hr = plat->pRenderTarget->EndDraw();

Thanks in advance!

Answer

TSM picture TSM · Oct 28, 2010

Transparency is a problem. The only window that support per-pixel transparency are WS_EX_LAYERED windows. These windows were designed for uses like drag-drop icons, and that leads to problems in every other usage.

Using D2D with WS_EX_LAYERED windows requires that you use a DXGI render target. To EndDraw, you get a DC out of the render target then pass that into the layered window and tell the layered window to update itself. (Try this with a HWNDRenderTarget - it will probably crash the device driver).

I suspect your window appears transparent because it's not drawing at all.

Another gotcha you may run into... if the window is sufficiently transparent, mouse clicks will go through it to the underlying window.