Bash bad substitution with subshell and substring

Question

A contrived example... given

FOO="/foo/bar/baz"

this works (in bash)

BAR=$(basename $FOO) # result is BAR="baz"
BAZ=${BAR:0:1}       # result is BAZ="b"

this doesn't

BAZ=${$(basename $FOO):0:1} # result is bad substitution

My question is which rule causes this [subshell substitution] to evaluate incorrectly? And what is the correct way, if any, to do this in 1 hop?

Answer 1

First off, note that when you say this:

BAR=$(basename $FOO) # result is BAR="baz"
BAZ=${BAR:0:1}       # result is BAZ="b"

the first bit in the construct for BAZ is BAR and not the value that you want to take the first character of. So even if bash allowed variable names to contain arbitrary characters your result in the second expression wouldn't be what you want.

However, as to the rule that's preventing this, allow me to quote from the bash man page:

DEFINITIONS
       The following definitions are used throughout the rest  of  this  docu‐
       ment.
       blank  A space or tab.
       word   A  sequence  of  characters  considered  as a single unit by the
              shell.  Also known as a token.
       name   A word consisting only of  alphanumeric  characters  and  under‐
              scores,  and beginning with an alphabetic character or an under‐
              score.  Also referred to as an identifier.

Then a bit later:

PARAMETERS
       A parameter is an entity that stores values.  It can be a name, a  num‐
       ber, or one of the special characters listed below under Special Param‐
       eters.  A variable is a parameter denoted by a name.  A variable has  a
       value  and  zero or more attributes.  Attributes are assigned using the
       declare builtin command (see declare below in SHELL BUILTIN COMMANDS).

And later when it defines the syntax you're asking about:

   ${parameter:offset:length}
          Substring Expansion.  Expands to  up  to  length  characters  of
          parameter  starting  at  the  character specified by offset.

So the rules as articulated in the manpage say that the ${foo:x:y} construct must have a parameter as the first part, and that a parameter can only be a name, a number, or one of the few special parameter characters. $(basename $FOO) is not one of the allowed possibilities for a parameter.

As for a way to do this in one assignment, use a pipe to other commands as mentioned in other responses.