No audio on Asterisk SIP call

sip asterisk sip-server
Sam picture Sam · Apr 5, 2011 · Viewed 31.5k times · Source

I almost managed to init a 2 sided call (click to call): 1st to my office and the 2nd to my cell using Michal Niklas answer (thanks Michal) on Asterisk click to call.

The major ISSUE is that the 2 call participants can not hear one each other, I used from-internal context for both of them. The system status web UI shows me 4 active channels and 2 external calls when the call is connected with both sides.

I configured the Channel: local/MY OFFICE PHONE@from-internal Extension: MY CELL PHONE

when I set the Channel to Sip/1 and check it with soft phone it works great!

Thanks for helping...

Answer

Suresh Kumar picture Suresh Kumar · Jul 25, 2013

seems to be NAT issue. here are some suggestions for sip.conf

put nat=yes in user definition and in [general] tag, put externip and localnet

e.g.

[general]
externip=<your global IP>
localnet=192.168.2.0/255.255.0.0

Related questions

Integrating Asterisk with WebRTC - ground up

I am trying to integrate Asterisk with webRTC. There was a query posted here but it barely provides any solution. I already have a basic webRTC infrastructure in place which I have tested for proof-of-concept. I use socket.io for …

Read More
Asterisk,SIP Retransmission timeout

I have created a sip trunk from One Asterisk(version 11.2.1) say 'A' server to another Asterisk server(11.7.0) say 'B', and I am getting sip response 200 ok. But when I start calling on a DID on Asterisk A then the call …

Read More
Asterisk to asterisk call: 403 Forbidden

I have 2 servers with Asterisks on them: 192.168.241.98 and 192.168.243.112. There is a valid registration on the first: register => wagateway:[email protected]:5060 CLI output: CLI> sip show registry Host dnsmgr Username Refresh State Reg.Time 192.168.243.112:5060 N wagateway 105 Registered Wed, 26 Jun 2013 16:42:42 And …

Read More