How to increase the request per second on amazon EC2 T2.micro instance?
I recently lunched a Amazon EC2 instance, the T2.micro. After installed Wildfly 8.2.0Final, I try to do a load test of the web server. I tested the server to serve a static page of less than 500 byte size, and a dynamic page that write and read mysql. To my suprise, I got the similar result, both test get the result of around 1000 RPS. I monitored the system using top -d 1, the CPU hasn't reach the max, and there are free memory. I think either EC2 has some limitation on concurrent connections, or my setup needs improvement.
My setup is CentOS 7, WileFly/Jboss 8.2.0 Final, MariaDb 5.5. The test tool is jmeter in distributed mode or command line mode. Tests were performed on remote, on the same subnet, and on the localhost. All get the same result.
Can you please help identify where the bottleneck is. Are there any limitations on Amazon EC2 instance that could affect this? Thanks.
Answer
Yes, there are some limitations depending of the EC2 instance type and one of them is network performance.
Amazon doesn't publish the exact limitations of each type of instance, but in the Instance Types Matrix you can see that t2.micro has a low to moderate network performance. If you need better network performance, you can check on the AWS instance types page where it shows which instances have enhanced networking:
Enhanced Networking
Enhanced Networking enables you to get significantly higher packet per second (PPS) performance, lower network jitter and lower latencies. This feature uses a new network virtualization stack that provides higher I/O performance and lower CPU utilization compared to traditional implementations. In order to take advantage of Enhanced Networking, you should launch an HVM AMI in VPC, and install the appropriate driver. Enhanced Networking is currently supported in C4, C3, R3, I2, M4, and D2 instances. For instructions on how to enable Enhanced Networking on EC2 instances, see the Enhanced Networking on Linux and Enhanced Networking on Windows tutorials. To learn more about this feature, check out the Enhanced Networking FAQ section.
You have more information in these SO and SF questions: