AWS API Gateway - using Access Token with Cognito User Pool authorizer?

Harry picture Harry · May 18, 2018 · Viewed 8.2k times · Source

I am configuring an app with various frontends (mobile and web apps) and a single API backend, powered by Lambda and accessed via AWS API Gateway.

As I'm planning to use Cognito to authenticate and authorize users, I have set up a Cognito User Pool authorizer on my API Gateway and several API methods.

With an architecture like this, it seems logical that my apps (e.g. an iOS or Vue.js app) are the Client applications from an OAuth perspective, and my API Gateway backend is a Resource Server. Based on this Auth0 forum post it seems clear that I should therefore use an ID token in my client app, and pass an Access Token to authorize my API Gateway resources.

When I hit the Cognito /oauth2/authorize endpoint to get an access code and use that code to hit the /oauth2/token endpoint, I get 3 tokens - an Access Token, an ID Token and a Refresh Token. So far so good, as I should have what I need.

This is where I've run into difficulties - using the test function on the API Gateway Cognito User Pool Authorizer console, I can paste in the ID token and it passes (decoding the token on-screen). But when I paste in the Access Token, I get 401 - unauthorized.

In my Cognito setup, I have enabled Authorization Code Grant flow only, with email and openid scopes (this seems to be the minimum allowed by Cognito as I get an error trying to save without at least these ticked).

Do I need to add some specific scopes to get API Gateway to authorize a request with the Access Code? If so, where are these configured?

Or am I missing something? Will API Gateway only allow an ID token to be used with a Cognito User Pool Authorizer?

Answer

Ravenscar picture Ravenscar · May 31, 2018

You can use an access token with the same authorizer that works for the id token, but there is some additional setup to be done in the User Pool and the APIG.

Even when this extra setup is done you cannot use the built-in authorizer test functionality with an access token, only an id token. Typical 80% solution from AWS!

To use an access token you need to set up resource servers in the User Pool under App Integration -> Resource Servers it doesn't matter what you use but I will assume you use <site>.com for the Identifier and you have one scope called api.

No go to the method in APIG and enter the Method Request for the method. Assuming this is already set up with an authorizer tested with the id token, you then add <site>.com/api to the Settings -> OAuth Scopes section.

Just by adding the OAuth Scope it will make sure that the token now has to be an access token and an id token is no longer accepted.

This is detailed here: https://docs.aws.amazon.com/apigateway/latest/developerguide/apigateway-enable-cognito-user-pool.html