What is different between u-boot.bin and u-boot.img

embedded-linux u-boot
FanQt picture FanQt · Apr 7, 2015 · Viewed 16.6k times · Source

I just compiled the U-Boot bootloader and I see a few file names in the u-boot program directory which are:

u-boot.bin
u-boot.img
u-boot.lds
u-boot.srec

Basically, I'm interested in the files with extensions .img and .bin. What is different between them? Is u-boot.img for SD card and u-boot.bin for flashing to NAND ?

Answer

shibley picture shibley · Apr 7, 2015

u-boot.bin is the binary compiled U-Boot bootloader.

u-boot.img contains u-boot.bin along with an additional header to be used by the boot ROM to determine how and where to load and execute U-Boot.

The way in which these files are deployed can depend upon the nature of your device, its boot ROM and where the files are loaded from.

Boot ROMs are generally provided by the SoC/CPU vendor. These days, many boot ROMs are capable of loading u-boot.img, reading the file's header, loading u-boot.bin into memory and finally executing it. Some boot ROMs are complex enough to load u-boot.bin directly or even the OS kernel. While others may load an intermediate bootloader (MLO/X-Loader) first which then takes responsibility for loading U-Boot as the secondary bootloader once external memory is initialized.

This image depicts the latter case as implemented by some TI OMAP processors: TI OMAP Boot Sequence

This boot process is reduced by some devices by moving many of the X-Loader tasks into U-Boot and placing boot parameters (such as memory addresses) into the header of u-boot.img avoiding the need for an intermediate bootloader.

You will need to investigate the properties of your device to determine how you should go about deploying U-Boot.

Related questions

Image vs zImage vs uImage

What is the difference between them? I know that u-boot needs a kernel in uImage format. The system I use first boots from stage 1 loader and then it calls u-boot. I want to discard u-boot and directly boot from stage 1 …

Read More
Understanding Linux load address for U-Boot process

I'm trying to understand embedded Linux principles and can't figure out addresses at u-boot output. For example, I have UDOO board based on i.MX6 quad processor and I got following output from U-Boot: U-Boot 2013.10-rc3 (Jan 20 2014 - 13:33:34) CPU: Freescale …

Read More
Getting U-boot's Version from Userspace

Does anyone know of a way to get U-boot version installed from userspace? There is the fw_printenv command that provides access to U-boot's environment variables, but not the version.

Read More