Load 32-bit constant to register in MIPS

assembly mips
lucasKo picture lucasKo · Oct 31, 2012 · Viewed 19.1k times · Source

I was confused about this part while I study MIPS.

The textbook written by Professor John L. Hennessy say if we get some big constant to load, we should

lui $s0, upper(big)
ori $s0, $s0, lower(big)

But why don't we just do

addi $s0, $zero, big

Since the registers are 32-bit, this is more strightforward, isn't it?

Answer

Paul R picture Paul R · Oct 31, 2012

The immediate argument passed to addi is only 16 bits. To load a 32-bit immediate value that is outside the range of a 16-bit value you need to do it in two goes, as in the example from your text book.

(Anticipating a further question, the reason there is no load immediate or add immediate instruction which takes a 32-bit immediate value is because the MIPS ISA uses fixed size 32-bit instructions, so there are always < 32 bits available for any instruction arguments - this is very common in RISC architectures.)

Related questions

Difference between "move" and "li" in MIPS assembly language

I was practicing converting C code into MIPS assembly language, and am having trouble understanding the usage of move and li in variable assignment. For example, to implement the following C line in MIPS: int x = 0; If I understand it …

Read More
How to Calculate Jump Target Address and Branch Target Address?

I am new to Assembly language. I was reading about MIPS architecture and I am stuck with Jump Target Address and Branch Target Address and how to calculate each of them.

Read More
Greater than, less than equal, greater than equal in MIPS

Given two registers $s0, $s1, how can I convert the following pseudocode into MIPS assembly language using only the slt (set on less than) and beq and bne (branch if equal, branch if not equal) instructions. if ($s0 > $s1) { …

Read More