Assembly Segments in opcodes

assembly x86 masm addressing-mode memory-segmentation
user1365914 picture user1365914 · May 30, 2012 · Viewed 8.4k times · Source

I noticed that in Assembly segments are used in opcodes.

Example:

MOV DWORD PTR SS:[EBP-30],30

I think that "PTR SS:" is used to specify that EBP-30 comes from the stack? (SS: stack segment) Am I right or am I completely wrong? :) And, could you please tell me the difference between the example above and

MOV DWORD PTR[EBP-30],30

And what about DS (data segment) used in opcodes?

Answer

Bo Persson picture Bo Persson · May 31, 2012 
MOV DWORD PTR SS:[EBP-30],30

There are two separate modifiers here, DWORD PTR and SS:.

The first one tells us that we want to store a word at the address pointed to. This is needed when the assembler cannot tell that from the operands of the instruction. Here 30 could just as well be a byte to store.

The SS: is a segment prefix, saying that we want to use an address relative to the stack segment. In this case it isn't strictly needed, because that is the default when using the ESP or EBP registers. So the second version of the instruction is identical to the first one.

Had you used EBX instead of EBP there would have been a difference!

Related questions

Referencing the contents of a memory location. (x86 addressing modes)

I have a memory location that contains a character that I want to compare with another character (and it's not at the top of the stack so I can't just pop it). How do I reference the contents of a …

Read More
What does OFFSET in 16 bit assembly code mean?

I am going through some example assembly code for 16-bit real mode. I've come across the lines: mov bx, cs mov ds, bx mov si, OFFSET value1 pop es mov di, OFFSET value2 what is this doing? What does having …

Read More
x86, difference between BYTE and BYTE PTR

What is the difference between these two lines? What PTR changes here? ;first mov BYTE [ecx], 0 ;second mov BYTE PTR [ecx], 0

Read More