Set baud rate to esp8266 at 9600

arduino-uno at-command esp8266
abdul rahuman picture abdul rahuman · Dec 13, 2015 · Viewed 19.2k times · Source

I brought an esp8266-12, it works at 115200 baud rate. I sometime connect it to arduino uno to work for some projects. It would be easy if I connect esp8266 with arduino at 9600 baud rate. The AT version is 0.25. I googled and saw the AT command set documentation it had a command to set baud rate. It was like

AT+ UART_DEF=<baudrate>,<databits>,<stopbits>,<parity>,<flow control>

But the problem is I don't know what these parameters are and how to set the parameters so that is works at 9600 baud rate with arduino.

Answer

abdul rahuman picture abdul rahuman · Dec 19, 2015

After a long time of searching, I found the parameters to work with Arduino at 9600 baud rate.

AT+UART_DEF=9600,8,1,0,0

Related questions

How to read temperature using arduino uno board with PT100 RTD sensor?

I am new to arduino programming. And almost inexperienced. I am looking to program my arduino Uno board to read 2/3/4 wire configuration of PT100 RTD sensor (in accuracy levels of atleast 0.5°C). The temperature range is 0 to 400°C and -50 …

Read More
OSError: [Errno 13] Permission denied: '/dev/ttyACM0' - using pyserial from Python to Arduino

Environment Linux Mint 17.1 Python 2.7 pyserial 2.7 Arduino UNO rv3 Desired Behaviour I'm trying to send three values from a Python application to Arduino. It works when doing the following from terminal: $ python $ import serial $ import struct $ ser = serial.Serial('/dev/…

Read More
arduino suddenly shows "avrdude: ser_open(): can't open device "\\.\COM3" after last upload

I am using arduino uno to make a sound detector. I uploaded a program, found error in the code that it returns unintended numbers unreasonably big. I also think I used wrong code for the module, but it was connected …

Read More