Decoding Raw H264 stream in android?
I have a project where I have been asked to display a video stream in android, the stream is raw H.264 and I am connecting to a server and will receive a byte stream from the server.
Basically I'm wondering is there a way to send raw bytes to a decoder in android and display it on a surface?
I have been successful in decoding H264 wrapped in an mp4 container using the new MediaCodec and MediaExtractor API in android 4.1, unfortunately I have not found a way to decode a raw H264 file or stream using these API's.
I understand that one way is to compile and use FFmpeg but I'd rather use a built in method that can use HW acceleration. I also understand RTSP streaming is supported in android but this is not an option. Android version is not an issue.
Answer
I can't provide any code for this unfortunately, but I'll do my best to explain it based on how I got it to work.
So here is my overview of how I got raw H.264 encoded video to work using the MediaCodec class.
Using the link above there is an example of getting the decoder setup and how to use it, you will need to set it up for decoding H264 AVC.
The format of H.264 is that it’s made up of NAL Units, each starting with a start prefix of three bytes with the values 0x00, 0x00, 0x01 and each unit has a different type depending on the value of the 4th byte right after these 3 starting bytes. One NAL Unit IS NOT one frame in the video, each frame is made up of a number of NAL Units.
Basically I wrote a method that finds each individual unit and passes it to the decoder (one NAL Unit being the starting prefix and any bytes there after up until the next starting prefix).
Now if you have the decoder setup for decoding H.264 AVC and have an InputBuffer from the decoder then you are ready to go. You need to fill this InputBuffer with a NAL Unit and pass it back to the decoder and continue doing this for the length of the stream. But, to make this work I had to pass the decoder a SPS (Sequence Parameter Set) NAL Unit first. This unit has a byte value of 0x67 after the starting prefix (the 4th byte), on some devices the decoder would crash unless it received this Unit first. Basically until you find this unit, ignore all other NAL Units and keep parsing the stream until you get this unit, then you can pass all other units to the decoder.
Some devices didn't need the SPS first and some did, but you are better of passing it in first.
Now if you had a surface that you passed to the decoder when you configured it then once it gets enough NAL units for a frame it should display it on the surface.